KOCH KHS 1250-S traversing single spooler
general information
- Nummer: 12544
technical details
- up to now used for: alloy steel wires, 41 CR4
- no. of spool reception: 1
- technical condition: without electric cabinet
- wire Ø min: 10 mm
- wire Ø max: 25 mm
- spool flange Ø max: 1250 mm
- total spool width max: 900 mm
- wire tensile strength: 900 N/mm²
- spool shaft: horizontal
- spool change : manual
- speed max: 150 m/min
- spool lifting and lowering device: hydraulic
- pintle clamping: hydraulic
- type of motor: AC motor
- motor power: 45 kW
- operation voltage: 380 V
- frequency: 50 Hz
- electrical cabinet: non-existent
-
additional data:
with traversing (motorised rollers)
with guide roller console with traversing pulley (electrically height-adjustable)
with attached hydraulic unit
with 1 x divisible bobbin
with bobbin ejection device (hydraulic)
with spool push-off device (hydraulic)
with hydraulic wire clamping and cutting device
without touch panel
without electric cabinet
consisting of:
divisible bobbin
-
suitable for:
The spool is equipped with a special locking system so that no tools are required to open and close the upper flange.
All functions run automatically by simply lifting or lowering.
For the fixing of the wire beginning the spool flange is provided with a corresponding wire clamping device, .for the wire end a steel band binding is required.
For the exact adjustment of the laying width, a spool flange can be adjusted laterally by max. minus 15 mm by means of a spanner through a gear wheel. This adjustment process is possible when the spool is clamped.
The spool is provided with 4 tying slots for a tape width of approx. 32 mm. - spool flange Ø: 1250 mm
- spool core Ø: 600 mm