BONGARD spooler with drawing die
technical details
-
up to now used for:
CRNI wire
-
suitable for:
Spooler with drawing die for instalation after oven or cleaning line
-
no. of spool reception:
1
-
wire Ø min:
0,8 mm
-
spool flange Ø min:
560 mm
-
spool flange Ø max:
760 mm
-
total spool width max:
500 mm
-
spool bore Ø max:
127 mm
-
wire tensile strength:
800 N/mm²
-
spool shaft:
horizontal
-
spool change :
manual
-
speed max:
30 m/min
-
automatic switch-off at wire break and full spool:
yes
-
layering device:
existent
-
spool lifting and lowering device:
non-existent
-
pintle clamping:
electric
-
manufacturer drive:
Control Tecnique
-
motor power:
3 kW
-
operation voltage:
400 V
-
frequency:
50 Hz
-
electrical cabinet:
existent
-
additional data:
- The Spooler is designed with a calibration pull out capstan (pullout disc)
- With pull-out disc (with ceramic ring zirconium oxide for replacement)
- With wire traversing, manufacturer Uhing
- Spooler designed to accommodate 2 x 5-row straighteners for straightening the wire before spooling.
- With pneumatic adjusted dancer for regulating the speed of the take-up spool
- With drawing die box
- With electrical control (frequency controller for main drive and drawing disc, gear motor for drawing disc).
- Operation of the spooler via control panel on the winder.
